3.3V 5V FTDI232R USB to TTL Serial Adapter Module

3.3V 5V FTDI232R USB to TTL Serial Adapter Module

5.0 (1 Reviews)
SKU: TS0486
Quantily: - +
Product Description



This USB to TTL serial adapter module can work with different types of computer systems and drivers. The power LED, TXD LED and RXD LED on the module can help indicate whether it works normally. With the build-in signal voltage switch, when you switch to 5V, the power at TXD and RXD will be 5V; if you switch to 3.3V, then the power is 3.3V. Therefore, if your device can take only 3.3V input, this module is a great choice. A 500mA self-restore fuse is used for over current protection. The module can also be used for general serial applications.


Chipset FT232RL.
Pin Definition: RXD, 5V, TXD, GND.
With RXD and TXD transceiver communication indicators.
With a build-in signal voltage switch – select 5V or 3.3V for the power at TXD and RXD as you switch.
A female and a male serial port, thus supporting two connecting ways.

Package List

  • USB-to-Serial Adapter Module x 1
  • Quality
  • Value
  • Price
Works perfect as a Pi TTY serial interface. By Todd 2019-12-11 08:32:18

Works on Raspberry Pi for TTY debug or serial interface. Supports both 3.3v (Pi) and 5v (Arduino)
Compatible with Windows 10 / Windows 10 IOT - Not a counterfeit chip! No drivers required, Windows 10 recognized immediately.
Much cheaper solution than the 20.00-30.00 cables that are offered by other vendors.
Well packaged with anti-static bag.

For Raspberry Pi:
TX -> RX (UART0_RX / GPIO15)
RX - > TX (UART0_TX / GPIO14)
5V - leave disconnected (Possibly could be used to power the Pi if your source port has the correct amperage >= 2 amp)

  • Review
Write Your Own Review *
  •   validation code  Unclear? Click the picture to replace the verification code
Your Rating