Calibrating the aircraft
Actually we have configured the aircraft previously and you can skip this step. But if the aircraft keeps tilting to one side during the flight, you can take these instructions.
Click FlightData, and check whether the horizontal line is in parallel with the yellow line or not. If yes, the calibration is ok; otherwise, follow the instructions below to operate.
Place the aircraft on a leveled surface, click Altitude, then Level to calibrate. When the progress bar goes to 100%, click Save.
Click FlightData again, and then you can see parallel lines now.
So you've finished the debugging. Now, let’s mount the propellers, and unlock the aircraft to check how it flies well.
Note: If an aircraft bumping happens, the setting parameters will change, thus you need to follow 3. CC3D Software Debugging to configure again.
Previous chapter: Check the Flight Mode
Next chapter: Setting Parameters Manually