Get tutorials Aircraft Model SF250

2 Connect the receiver

The wire connection for the PWM Mode is mentioned in the video, but the wiring differs for various receivers in different modes, so you need to adapt it to the actual situation. First let's check the pins of the CC3D flight controller.

CC3D Flight Controller

The pins of CC3D flight controller is as shown below. When wiring, you should be clear about the pins’ name and connect them correctly, or a short circuit may happen.

 qqqq

 

Connect to the Receiver

The CC3D flight controller supports three modes: PWM, PPM, and SBUS. Thus as long as your receiver supports one of these modes, it works with this kit. The wiring for three modes is described below.

For PWM Mode:

Prepare eight wires for a PWM mode receiver, and connect the receiver and the flight controller as shown below. You can modify the corresponding channel in software debugging part.

Flight Controller

Receiver

GND

GND

PWR

VCC

1

CH1

2

CH2

3

CH3

4

CH4

5

CH5

6

CH6

 qq

 

 

For PPM Mode:

Flight Controller

Receiver

GND

GND

PWR

VCC

6

PPM

For PPM mode, since GND, PWR, CH1are connected together, we need to connect the 3pin cable to other position, and then connect CH6 to PPM(CH2).

 qq

For SBUS Mode:

Flight Controller (Main Port)

Receiver

GND

GND

VCC

VCC

TX

N/A

RX

SBUS

 qq

 


Previous chapter: 1 overview

Next chapter: About the Radio Transmitter

SunFounder
Oct 10 2017 at 03:33 am



© Developed by CommerceLab