This instruction manual applies to the aircraft kits including the Q250 kit, SF250 components kit, and SF250 assembled kit (with radio transmitter).
Since the Q250 and SF250 kit are provided in components, you need to mount them yourself. For different aircrafts, check the respective assembly tutorials below.
Visit our website www.sunfounder.com, click VIDEO, scroll down to Aircraft Model and find Q250. You can see 6 videos there on the page, including a basic introduction one and 5 detailed tutorials. The tutorial videos are marked with numbers in order. Aircraft assembly requires great carefulness and patience, so please follow the steps in the video closely.
On our website, go to VIDEO -> Aircraft Model -> SF250. You can see 6 videos including a basic introduction one and detailed tutorials which are marked with numbers in order. Aircraft assembly is a task that requires carefulness and patience, so please follow the steps in the video for operation.
For SF250 Assembled Kit (with Radio Transmitter)
For the SF250 assembled kit, most of the components have been assembled except the propellers and the battery before arriving at your doorstep. Please finish the assembly by following the tutorial in www.sunfounder.com -> WIKI -> Drones/Model Aircrafts->CC3D -> SunFounder 250+Radiolink T8FB Remote Controller(Assembled).
The receiver included is a PWM mode one with firmware burnt. If the firmware is missing due to an aircraft collision or some other reasons, you need to reburn it; please refer to 3. CC3D Software Debugging.
Previous chapter: Contents
Next chapter: 2 Connect the receiver